Broadland Sea Tackle - Miscellaneous

Stormsure

15g Tube of flexible repair adhesive that can be used on waders, leather boots, shoes, wellington boots, wellies and waterproof clothing, tents, bivvies, ground sheets etc.
Works on most man-made and natural fabrics, but not Polythene, Polypropylene or PTFE .
The only glue you need to fix a rip leak or tear on any flexible material or fabric.
Very strong, but remains flexible when cured.
Very resistant to abrasion.

£4.99

GT's Rocket Fuel - Red Label (Reel Lubricant)

This now famous oil was designed especially for long casting conventional reels.
It will give you more control at the start of the cast where it's most needed and then thin out for the duration of the cast where less braking is required, most other oils stay the same viscosity throughout.
The Red Formula is a tad easier to control and will last a little longer than the Yellow label. When used in conjunction with centrifugal brake blocks or magnetic controls it enables the caster to achieve great distance time after time without using the mechanical/end cap spool control on a totally free running reel.
This is the one we recommend to slow down those reels that are a little unruly and for the less experienced caster in most fishing applications.
30ml bottle

£4.75

GT's Rocket Fuel - Yellow Label (Reel Lubricant)

This is the original Rocket Fuel Formula and is for use in smaller Hi-Speed conventional reels.
The Yellow Formula is recommended for more experienced casters and/or those willing to maintain their reels a little more than required with the Red Label above, however it's a great oil for long distance fishing applications and still very durable.
It may also be used on level wind parts but again, a little more maintenance may be required.
30ml bottle

£4.75

Stormcure

Stormcure liquid can be used as an Accelerator, Pre-Cleaner and Primer on Stormsure to make permanent, flexible and waterproof repairs on most materials and fabrics.

Directions for use

As a Pre-Cleaner and Primer:
Clean off mud and dirt from the damaged area with soap and water.
Roughen surface with sandpaper, if appropriate.
Clean with a small amount of Stormcure Liquid on a soft cloth.
Allow to dry. This will degrease the surface before making the repair with Stormsure.
It also acts as a primer for the surface, ensuring the best possible adhesion.

As a Cure Accelerator:
Mix 4 parts of Stormsure Adhesive with 1 part of Stormcure Liquid using a stick.
Apply to the damaged area quickly and allow to fully cure.
Typically, the full cure will then take 2 hours instead of 12 hours.
Handle after 30 minutes.

£3.85